A Proven Way To Fix The PS3 YLOD
There are lots of so-called cures for the PS3 YLOD error but how do you know if any of them really work? One of the major problems with carrying out a repair on your own is that, usually, you only get one attempt to fix the problem. Some of the repair methods that you can find on-line are dodgy to say the least and a few of them can actually end up causing more harm than good. The fact of the matter is, if you screw up even a single step you can end up making a whole mess of the repair and rendering your PS3 totally useless.
This fear of ruining the console is probably the main reason why so many gamers are content to sit back and let someone else do the work. Of course, this can cost several hundred dollars – especially if you get Sony to carry the repair out – but did you realise that most repair shops don’t even give a a guarantee with their work. At best you might get a couple of months warranty against the same failure happening again, but this is the exception rather than the rule. So, when you come to think about it, there’s really not that much of a downside to having a go at repairing the PS3 YLOD on your own. You can actually save loads of cash, and, in addition, its very interesting. After all how often do you get the chance to take your console to bits and really find out how it works.
Dont Just Dive In If You Want To Get Rid Of The PS3 YLOD For Good
The one major recommendation that I would offer is not to just dive in and pull the machine apart. There are several techniques that require a full understanding of how they work – and what can go wrong with them – before you carry them out.
The method that I’ll describe here, and one of the most commonly used ones, is called the Re-Flow repair. This is generally done in one of two ways but the end result is the same. The PS3 YLOD is caused by the system overheating and internal damage being caused to the components. The most common fault that happens when the console overheats is that the thin lines of solder connecting the processor and the GPU – the main graphics chip – become damaged. These tracks are responsible for the data flow between the components and, like a railroad , if they are broken then the data can’t flow between its source and destination. The net result is a broken console. The whole point of the Re-Flow technique is to heat the solder on the board to a point where it re-flows and bridges the gaps caused by the initial problem.
The simplest way to perform this process is by taking the console apart and using a high powered hair dryer to heat the board. The whole process usually takes about 15-25 minutes and is quite safe and easy to carry out. Another way to achieve the same effect, but one that I don’t recommend is to run the console without any cooling. The obvious problem with this process is that the other components on the board run a high risk of burning out and thus making the problem worse.
Its vital that you let the whole system cool down completely before putting it back together again and seeing if the repair has worked. This takes about 30 minutes, during which you have to resist the temptation to start it up and find out if your work has been successful. Don’t be fooled into believing that the PS3 YLOD error has been sorted for good just because the board is cool to the touch. As the solder cools it become brittle and so needs time to completely cool and solidify again. Turning the machine on prematurely is a sure-fire way to trigger the PS3 YLOD problem all over again – and its back to the drawing board!
This method of repairing the PS3 YLOD is one of the most widely used ones. Although the repair itself is fairly easy most of the work comes taking the console apart and putting it back together again and for this part of the process I always recommend that you consult a qualified repair technician or, better still, get hold of one of the many decent PS3 YLOD repair guides that are available on the net.
Click Here To Find Out More About PS3 YLOD Repair Guides
Recent Comments